A quick and easy fix for a leaking pipe can be binding a piece of rubber over the pinhole to stop the water from spurting out.
As you can imagine, this is not a permanent fix and it will need to be dealt with properly before the rubber inevitably comes away and your pipes are leaking once again.
A good permanent fix would be to solder the pipe.
If you don’t already know, soldering is the process of joining two pieces of metal together by using a third filler material. That filler material being the solder itself.
At a heat of around 400 degrees Fahrenheit, the solder metal will become liquid and coats the two pieces of metal that you wish to join. After being left to cool, the solder will harden and the pieces will be joined together.
This process is not to be confused with welding for example, which is when the two materials are heated to such a high degree that they can melt and fuse together without using a third joining piece. Soldering can also be non-permanent, if for whatever reason you decide you want to separate back the materials back into two pieces.
Soldering is commonly used in electronics and a wide variety of other trades outside of plumbing.
The following will be some short and simple tips to soldering pipes in general, rather than a detailed guide. A handy reference guide if you will, with some important tips that many people forget. If you prefer calling a professional plumber who can do that for you and you are living in El Paso, we can recommend you Genesis plumber – visit website.
Forget Propane Gas
You will want to use a MAPP gas torch rather than a propane torch when heating the solder.
MAPP will get the solder to the required temperature faster and more efficiently than propane.
But be careful, MAPP can become too hot quite fast, which can burn the flux and overheat the joint.
Use Flame-Retardant Blankets to Cover Any Wood
Copper pipes often run through wooden planks or beams so you will want to be extra careful when using your gas torch them.
You can buy flame-retardant blankets to cover these parts at most hardware stores. Place these against the wood or any other surrounding flammable areas.
But also exercise common sense; try and keep the torch away from the flammable areas anyway. The blankets should be a second layer of protection.
Wrap A Wet Rag Around The Other Soldered Joints
If your pipes are in particularly bad shape and you have to solder multiple joints, you will want to make sure that you are not reheating the joints you’ve already done when you move onto the next one. So wrap some wet cloth around the joints you’ve completed, letting them cool down and harden without having to worry about errant heat making them ineffective.
Don’t Use Too Much Solder
More isn’t always better and that is definitely true in this case. This will take obviously take some practice if you’re new to soldering, but you only want to use just as much as you need. No more. No less.
Using not enough won’t bind the materials together, but using too much can restrict the water flow. They can even harden as lumps inside the pipes that can break off and cause yet another hole for you to deal with.